System Error Codes
Station Programming Error Codes
B-4 Strata CTX Programming - Part 4: Appendices 04/03
Station Programming Error Codes
Program Code FB
Sub-
parameter
Error Descriptions
200
33
)%
The entered Shelf/Slot/Circuit value is out of range.
49
)%
The selected PDN(s) conflicts with an existing PDN(s)
assignments for the selected circuit.
49
)%
Station Type cannot be changed.
49
)%
)%
The desired DN does not exist.
51
)%
The entered value conflicts with an existing numbering
scheme.
52
)%
The entered value conflicts with an existing ISDN assignment
etc.
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
The DN does not exist.
80
)%
A PCB without “DKT/SLT setting allowed” is designated for a
PCB connecting the selected ISDN extensions.
96
)%
The allowed number of extensions has been exceeded.
98
)%
The quantity of station speed dial bins entered exceeds the
system's capacity.
201
51
)%
The entered number is not the extension number.
52
)%
The entered number is not the extension number.
80
)%
The entered value is not a valid extension.
202
33
)%
The equipment number entered is out of the range.
49
)%
PCB assignment is not set for the ISDN card connecting
selected extensions.
49
)%
The entered equipment is using as other ISDN extension.
49
)%
An ISDN trunk channel group conflict has been detected.
49
)%
Although the P-P connection was selected, an additional DN
is registered.
49
)%a)%
The desired value conflicts with existing ISDN extensions.
51 -
The Primary DN entered conflicts with a value of an existing
numbering scheme.
51
)%)%
a)%
The desired value conflicts with existing number schemes.
52
)%
A DN used for DKT extensions is designated.
52
)%a)%
The additional ISDN extension number cannot be registered.
The number is already in use by a DKT extensions, etc.
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
The DN entered is invalid.
To Next Page
Loading...
