Toshiba Strata CTX - Page 415

System Error Codes
Station Programming Error Codes
Strata CTX Programming - Part 4: Appendices 04/03 B-5
System Error Codes
202
80
)%
A PCB without ISDN extension settings allowed’ is designated
for the PCB connecting the ISDN extension(s) selected.
96 )%
The number of channel group exceeds the system capacity
when ISDN station is registered.
96
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
98
)%
The quantity of station speed dial bins entered exceeds the
system’s capacity.
203
49 )%
The new DN value conflicts with an existing value DN, PhDN,
etc.
51 -
The Primary DN entered conflicts with a value of an existing
numbering scheme.
51
)%
The new DN value conflicts with an existing numbering
scheme value.
52
)% The new DN value conflicts with existing group extensions.
80
)% The new DN value does not exist.
204
49
)%
The number of attendant consoles exceed the number
specified in the system.
52 )% DKT is not assigned to DN (ISDN, etc.).
80 )% The DN entered is an extension number that does not exist.
98
)% Allowable Feature Button number is exceeded.
98
)% Allowable Call History Memory size is exceeded.
205
33
)%
100
110
120
130
140
Sub-parameters must be assigned.
33
120 The line number entered is out of range for the system’s
capacity.
48  Required parameter for each Feature Code is not entered.
49
)%
110 Two or more PhDNs with the same value are registered to one
extension.
49 )%
700
790
800
810
820
830
Only Feature Code(s) allowed for Attendant Console is
registered.
49
)%
610 Two or more DSSs with the same value are registered to one
extension.
49
)%
120
130
560
610
While assigning sub-parameters to a DN: A DN was selected
that does not exist in the system.
Program Code FB
Sub-
parameter
Error Descriptions