System Error Codes
Trunk Programming Error Codes
Strata CTX Programming - Part 4: Appendices 04/03 B-11
System Error Codes
Trunk Programming Error Codes
Program Code
Occurred
FB
Sub-
parameter
Error Descriptions
300
33
)%
The equipment number entered is out of the range.
49
)%
When modifying previously assigned equipment:
• The designated PCB Type does not allow CO trunk
assignments.
• The designated circuit does not allow CO trunk
assignments.
49
)%
The ISDN ILG number is designated for analog trunks or the
entered ILG number does not exist in the system.
49
)%
The ISDN OLG number is designated for analog trunks or the
entered OLG number does not exist in the system.
49
)%
)%
A conflict exists between the ILG number and the OLG
number trunk type.
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
A trunk number that does not exist in the system has been
selected.
80
)%
The entered ILG number does not exist in the system.
80
)%
The entered OLG number does not exist in the system.
96
)%
Allowable number of trunks has been exceeded.
96
)%
The line number entered exceeds the system’s capacity.
301 6
)%
A trunk number that does not exist in the system has been
selected.
302
33
)%
The equipment number entered is out of the range.
48
)%
Dch position is not set to 16. When setting the time slot
pattern for a 2048 kbps interface, this value must be set to 16.
49
)%
The type of ILG or OLG entered in not an ISDN.
49
)%
The ILG or OLG entered does not exist in the system.
50
)%
The T-Wait Timer can only be enabled if the Protocol is set to
National ISDN.
52
)%
The entered Channel Group conflicts with an existing ISDN
extension(s), etc.
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
The entered Channel Group number does not exist in the
system.
80
)%
An ISDN trunk cannot be assigned to the designated Shelf/
Slot/Circuit.
80
)%
The designated ILG does not exist in the system.
80
)%
The designated OLG does not exist in the system.
To Next Page
Loading...
