Toshiba Strata CTX - Page 428

System Error Codes
Service Programming Error Codes
B-18 Strata CTX Programming - Part 4: Appendices 04/03
507
33
)%
The DDCB Equipment number entered is invalid.
33
)%a)%
The destination number value is out of range (when
destination type is Paging Group).
33 )%a)%
The allowable number of Paging Groups have been
exceeded.
33
)%
The entered Ring Duration is invalid.
49
)%
Door Phone number entered conflicts with an existing Door
Phone number.
49
)%
The equipment assigned in DDCB Equipment Number is
already in use.
49
)%
The entered value conflicts with an existing DKT extension.
52
)%
The entered Circuit conflicts with an existing door lock.
80
)% The entered Door Phone number does not exist in the system.
80 )% The PCB Type designated for this circuit must be a DKU.
82
)% The entered Door Phone number does not exist in the system.
96
)% The allowable number of Door Phones has been exceeded.
508
33 )% The entered equipment value is invalid.
49 )%
The designated BIOU PCB circuit is used by another device
(Night Bell, etc.), or two or more door locks are designated for
the same BIOU PCB.
49
)%
The PCB Type designated for this DDCB circuit must be a
PDKU or BDKU.
49 )%
The DDCB Equipment number entered conflicts with an
existing door lock.
52
)%
Other devices (DKT extensions, door phones, etc.) are
designated for the specified DDCB circuit.
96
)% The allowable number of Door Locks has been exceeded.
509 -

No error occurs for this command except for common errors.
510 49 )% The specified COS Override Code digit is invalid.
512 -
 No error occurs for this Program except for common errors.
513 80
)% ILG number enter does not exist.
514 80 )% The entered OLG number does not exist.
515 -
 No error occurs for this Program except for common errors.
Program Code Occurred FB
Sub-
parameter
Error Descriptions