Toshiba Strata DK 16 - Page 280

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-30-
TABLE RM-W
PROGRAM 22
DATA STATION HUNTING (DATA CALL ONLY)
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROGEnter the Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 22
P22
Enter Program Number 22
Press CR.
3 P22 03Refer to the record sheet and enter the required
port number.
Example: Port 03, enter 0 3.
4 Enter #. The present data will be displayed.
P22 03# NN
5 Refer to the record sheet and enter the port number
that will be the hunt point.
Example: Port 00, enter 0 0.
6
P22 03# NN 00
P22 ##
P
To Exit Program/Store Data
A)
B)
C)
P
P22 03# NN 00
To store data, press CR.
Continue returning to step 3 until all
data is entered.
To exit this program, press # # CR.
Program 22
TABLE RM-X
PROGRAM 28
DSS CONSOLE/ATTENDANT TELEPHONE ASSIGNMENTS
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 28
P28
Enter Program Number 28
3 P28 1 1 2Refer to the System Record Sheet and enter the required DSS
console number (1 ~ 2).
The system will display the telephone to which the
DSS console is assigned.
Example: DSS console number 1 is assigned to telephone
number 1.
Press CR.
4 P28 1 1 2
P28 ##
P
To Exit Program/Store Data
Refer to the System Record Sheet and change if required.
Example: Assign DSS console 1 to electronic telephone 2.
Enter: 2.
A)
B)
C)
To store data, press CR.
Continue returning to Step 3 until all data has
been entered for this program.
To exit this program, press # # CR.
NOTE:
This pro
g
ram applies to di
g
ital and electronic DSS consoles and di
g
ital and electronic telephones.