Setting System Parameters
Speed Dial—Advanced Features
32 Strata DK System Administrator Guide 5/00
4. Enter up to 12
alphanumeric
characters, (see the
figure at the right)
using the station
keypad.
5. Press
0RGH.
6. Press [PDN], then
enter the desired CO
line access code, plus
the telephone number
(20 digits maximum).
The number appears as you entered it. Speed Dial
numbers and memos and their corresponding two- or
three-digit codes can be recorded on the Speed Dial
Memo Directory at the back of this guide.
Note If telephones use direct appearing CO line
buttons to place outgoing calls–do not press
[PDN] in Step 6.
7. Press 5HGLDO. The data is recorded into memory.
8. Repeat Steps 1~7 to
enter more names/
memos.
2358
Toggles between
alphanumeric
characters
Scrolls alpha/
special characters
Move Left
Move Right
(Alpha mode only)
To Next Page
Loading...
