Program *44-3 Incoming Digit Translation (Tie Lines)
System & Station
Strata DK40 Programming Manual Spring 1999
3-105
Program *44-3
Incoming Digit Translation (Tie Lines)
Program Type:
Toll Restriction
Initialised Default:
Initialised Data is Blank
Note By Pressing “Key 1” = I/P Don’t Care
“Key 2” = I/P Don’t Care
If Key 1 is used to I/P X2 then translation will be performed on the first digit X1 only
If Key 2 is used to I/P X2 then translation is performed on the first digit X1, but the digit
X2 is deleted from the incoming number
Program *44-3 Overview
Enables the system to translate the first two digits it receives. Up to a maximum of five
different translations can be programmed.
Example: If in Program 44-31 the data entered was 60 200, this would allow the system on
receipt of the digits 60, to translate them and actually dial 200.
(QWHU 3URJ 0RGH 0 6SNU
*
77+ROG 6SNU 6 ;4 ;5 <4 <5 <6 +ROG 0 6SNU & & +ROG 0 6SNU & & +ROG
Number to be translated Translation
X1 X2 Y1 Y2 Y3
31
32
33
34
35
Enter up to three digits that X1 and X2 must
be translated to
Enter 1 - 5
Enter one of the five translations
that can be programmed in
Enter up to two digits that must be
translated
To Next Page
Loading...
