System & Station
Program 80 EKT and DKT Ringing Tones (Exchange Line Calls)
3-180
Strata DK40 Programming Manual Spring 1999
Program 80
EKT and DKT Ringing Tones (Exchange Line Calls)
Program Type:
Station
Initialised Default:
Tone 1 is assigned to all ports
Program 80 Overview
Distinctive system ringing sends a different ring tone for Intercom and Tie line ringing than
that sent for DDI or DEL and exchnge line ringing, as standard. In addition, exchange line
ringing at electronic and digital telephones can be different from one phone to another. Three
choices are available with Program 80; see the record sheet for the tone frequencies available
with each choice.
(QWHU 3URJ 0RGH 0 6SNU ;3+ROG 0 6SNU & +ROG 0 6SNU & & +ROG 0 6SNU & & +ROG
Processor Port Range
DK40 000~027
Ringing Tone (Code) Ringing Tone (Code)
Port
Number Tone 1 (1) Tone 2 (2) Tone 3 (3)
Port
Number Tone 1 (1) Tone 2 (2) Tone 3 (3)
000 014
001 015
002 016
003 017
004 018
005 019
006 020
007 021
008 022
009 023
010 024
011 025
012 026
013 027
Ringing Tone Code
1 = Tone Option 1
2 = Tone Option 2
3 = Tone Option 3
SELECT = Station Logical Port Number
Enter the telephone port number for which
the ringing tone is being defined.
To specify a port range, enter XXX
*
XXX
(low port
*
high port).
*Incoming Line Call distinctive ring tones apply to DDI and loop start Exchange lines.
Ring tone for internal or [DN] calls, and tie line incoming calls is 500 Hz for all telephones.
Ring Tone Option 1 2 3
Incoming Line Call* 500/640 Hz 1200/1500 Hz 800/1000 Hz
Transferred Line Call 540/760 Hz 1300/1780 Hz 880/1180 Hz
To Next Page
Loading...
