Toshiba Strata DK40 - Program 56 LCR Station Group Assignments

Least Cost Routing Program 56 LCR Station Group Assignments
5-28
Strata DK40 Programming Manual Spring 1999
Program 56
LCR Station Group Assignments
Program Type:
Least Cost Routing
Initialised Default:
Assigns all stations to Group 1
Program 56 Overview
The purpose of this program is to assign all defined station ports to one of four LCR Station
Groups (see Program 56, record sheet notes).
◆ Station groups are completely independent of one another. Therefore, each station group
must be defined separately.
◆ A station can only belong to one station group. To enter data simply enter the station
port number followed by the group number.
◆ For Tie lines used to make outgoing exchange line calls use station port numbers 028 ~
039 for Tie lines 1 ~ 12 respectively, (i.e. use station port 030 for Tie line 3).
(QWHU 3URJ 0RGH 0 6SNU 89+ROG 0 6SNU & +ROG 0 6SNU & & +ROG 0 6SNU & & +ROG
Processor Port Range Tie Line Station Port Range LCR Station Groups
DK40 000~027 028 ~ 039 1~4
Port Port Tie Line Station Port
Port
Number
LCR Station
Group No. (1~4)
Port
Number
LCR Station
Group No. (1~4)
Port
Number
LCR Station
Group No. (1~4)
000 014 028
001 015 029
002 016 030
003 017 031
004 018 032
005 019 033
006 020 034
007 021 035
008 022 036
009 023 037
010 024 038
011 025 039
012 026
013 027
Enter LCR Station Group (1~8)
SELECT = Station Logical Port Number(s)
Enter port numbers of stations being assigned.
To add a port range, enter XXX
*
XXX (low port
*
high port).