Program 92 Initialising Misc. Backup RAM
Initialisation & Test
Strata DK40 Programming Manual Spring 1999
2-11
or...
5 + LED Buttons 01 & 04
Clears System Speed Dial and LCD memos assigned
to system speed dial numbers.
92 Select = 2
Common Dial Clr
or...
6 + LED Buttons 02 & 03
Clears Character Message Memory (station and
system) and user name display.
92 Select = 3
Msg Clr
or...
7 + LED Buttons 02 & 04
Clears timed reminders.
92 Select = 4
Tmr Reminder Clr
or...
8 + LED Buttons 01 & 05
Presets the Ring, Speaker, Mute Ring, and Intercom
Tone, BGM, volume levels of all digital telephones to
approximately mid-range.
92 Select = 5
DKT VR Initial
or...
9 + LED Buttons 02 & 04
Clears all Lock ID Codes that have been set.
92 select = 6
Backup RAM Clr
or...
;4 + LED Buttons 02 & 05
Creates a reference table of the PCB’s installed in slots
for fault diagnostics.
92 select = 81
status Chk INIT
or...
;5 + LED Buttons 03 & 05
Performs a manual test and prints via SMDR
92 select = 82
status Check
or...
<
+ LED Buttons 03 & 04
Clears Call Forward and Message Waiting (R3) Memory
except Fixed Call Forward Memory.
92 Select = 9
Back Up RAM Clr
7. +ROG
LEDs lit in Step 5 turn off to secure data in system
programming. Repeat Steps 4~6 until Step is
completed.
92 Select = (1~0)
Data Programmed
8. 6SNU +6SHDNHU,
Prepare system for another selection (go back to Step
5) or exit Program 92 (continue with Step 8).
92 Select =
Action (press buttons + LED Buttons) LCD Response
To Next Page
Loading...
