System & Station
Program 02 Station Physical Port Display and/or Change
3-2
Strata DK40 Programming Manual Spring 1999
Program 02
Station Physical Port Display and/or Change
Program Type:
Station
Initialised Default:
Logical port number = physical port number
Program 90, 91-1, or 91-9 initialises Program 02
Program 02 Overview
Program 02 enables you to enter a logical port to display the associated physical port. You
then have the option to assign a new physical port to the logical port. (To return ports to their
initialised settings, see Programs 90 and 91.)
Notes
◆ Record port locations on Program 04 record sheet.
◆ The system allows only like ports to be reassigned (see below).
(QWHU 3URJ 0RGH 0 6SNU 35+ROG 0 6SNU +ROG 0 6SNU & & +ROG 0 6SNU & & +ROG
Processor [PDN] Port Range
DK40 000~027
Allowed Not Allowed
Digital-to-Digital Ports (PDKU-PDKU Ports)
DSS, BGM or Amplified Conference Ports
should not be reassigned
Electronic-to-Electronic Ports (PEKU-PEKU Ports) Door Phone Ports should not be reassigned
Standard Tel to Standard Tel Ports (KSTU-PSTU-
RSTU)
Tie line Ports – should not be reassigned
PDKU to PEKU – cannot be exchanged
PSTU to PDKU – cannot be exchanged
PEKU to PSTU – cannot be exchanged
To Save existing Physical Port
6SNU
SELECT = Logical Port Number
The physical port number associated with the logical
telephone port displays after the logical port number
is entered.
Enter new Physical Port
to change existing Physical Port
To Next Page
Loading...
