CALL FUNCTIONS (continued)
TRUNK QUEUING
This feature provides a means for station users to be
placed in a waiting queue for a busy outgoing trunk
group, and to be called back when a trunk in the group
is available.
TO USE TRUNK QUEUING
1) Lift the handset.
2) Depress the
m
key.
l
You will hear intercom dial tone.
l
INT LED will flash at the l-use rate.
3) Dial the desired trunk group access code (or dial
61’
and the CO line number) :
4A)
If there is an idle trunk, you will be connected and
can dial the desired telephone number.
l
You will hear CO dial tone.
l
CO LED will flash at the l-use rate.
l INT LED goes off.
4B)
If all trunks are busy, you will hear busy tone.
5) Depress the
m
key or dial
B
to set Automatic
Callback.
l Busy tone will stop, you will hear dial tone for 2
sec. and then busy tone again.
l You may go on-hook or make other calls while
waiting for a trunk to become available.*
6) When a trunk becomes idle:
l
Your telephone will ring at a fast rate.
l
The CO LED will flash at the l-called rate.
7) Lift the handset within 6 sec. to prevent the call-
back from being cancelled.
l
You will hear CO dial tone.**
l
The CO LED will flash at the l-use rate.
8)
Dial the desired telephone number.
9)
Hang up when the call is completed.
(continued)
P-TOSHIBA
To Next Page
Loading...
