Toshiba T1200 - 4.10 Removing;Replacing the FDD

4.10 RBIIOVDIG/RBPLACDG 'l'BB POD
1. Confirm that the POWER switch is off.
2. Remove the FDD base as directed in part 4.9.
3. Remove the three flatheaded countersunk screws (A) and the
FDD GND (B) from the FDD base.
'11---_ (8)
FIGURE 4-16 Removing the FDD
4. To install a new FDD, follow the above procedures in
reverse.
BarB: Make sure to place the FDD cable in the location
provided for it on the FDD base.
4-14