Toshiba T1200 - Procedure 2: Message Check

PROCBDOIlB 2
Message Check
1. When the diagnostics disk is inserted into the FDD and the
POWER switch is turned on, either message (a) or message (b)
should appear.
(a) Place system disk in drive
Press
any key when ready ••••
(b) Non-System disk or disk error
Replace and press any key when ready
2. If ei ther of the above messages is displayed, the contents
of the floppy disk are damaged, or some other disk than the
diagnostics disk has been inserted into the FDD. Change the
diagnostics disk. If loading then occurs, go to PROCEDURE
4~ if loading does not occur, go to PROCEDURE 3.
3. If neither of the above messages appears, go to PROCEDURE 5.
2-18