Toshiba T1200 - Procedure 4: FDD Test Execution

PROCBDUitB 4
FDD Test Execution
1. Run the floppy disk test which is indicated in the
Diagnostic Test Menu.
2. If an error is generated during the floppy disk test, an
error code and status will be displayed as indicated in the
following table. Follow the directions provided in the
table.
3. If no error is generated, the FDD is normal.
TABLE 2-4 FDD Error Statuses
CODE STATUS
01 Bad Command
02
Address Mark Not Found
03 Write Protected
04
Record Not Found
06
Media removed on dual attach card
08
DMA Overrun Error
09
DMA Boundary Error
10
CRC Error
20
FDC Error
40
SEEK ERROR
60
FDD not drive
80
Time Out Error (Not Ready)
EE
Write buffer error
2-20