Toshiba T1200 - Procedure 3: Hard Disk Drive Test Execution

PROCBDURB 3
Hard Disk Drive Test Execution
CAUTION: The contents of the hard disk will be erased when the
test program is run. Before running the test, transfer
the contents of the hard disk on the floppy disk. This
can be done wi th the MS -DOS BACKUP command. (See the
MS-DOS manual for details.>
1. Insert the diagnostics disk into the FDD and load the test
and diagnostic programs.
2. Run the hard disk test which is indicated in the diagnostics
test menu.
3. If an error is generated during the hard disk test, an error
code and status will be displayed as indicated in the
following table. Go to PROCEDURE 3.
4. If no error is genera ted, the HDD is normal. Enter the
MS-DOS FDISK command which will set the partition. Then
enter the MS-DOS FORMAT command. (See the MS-DOS manual for
details. )
TABLE 2-5 HDD Error Statuses
CODE STATUS
01
Bad command error
02
Bad address mark
04 Record not found
05
HOC NOT RESET
07
Drive not initialize
09
DMA Boundary error
OA Bad sector error
OB
Bad track error
10
ECC error
11 ECC recover enable
20
HDCerror
40 Seek error
80
Time out error
AA
Drive not ready
BB Undefined
CC
Write fault
EO
Status error
FO Not sense errorlHW.code = FF)
2-26