Toshiba T1200 - Procedure 5: Jumper Strap Check

PROCBDURB 5
Jumper Strap Check
1. Confirm that a jumper strap (PJ 11) on the system PCB and a
jumper strap (PJ 9) on the hard disk control PCB is as
following status. (Refer to part 1.2.1 and 1.5.1.)
PJ 17 (system PCB) •••••••••••••••••. Open
PJ 9 (hard disk control PCB) Short
2. If the jumper strap is above status, go to PROCEDURE 6.
3. If the jumper strap is not above status, set the jumper
strap correctly.
() Pl9
Hard Disk Control PCB
PUI put
--
System PCB
FIGURE 2-9 Jumper Straps
2-28