Toshiba T1200 - 3.19 Running Test

3.19 RURRDIG TBST
3.19.1 Program description
This program automatically runs the following tests in sequence.
1. System test (subtest number 01)
2. Memory test (subtest number 01, 02, 03, OS, 06)
3. Display test (subtest number 01 to 07)
4. FOO test (subtest number 02)
5. Printer test (subtest number 03)
6. Async test (subtest number 01, OS, 08)
7. HOD test (subtest number 01, OS, 08)
When running an FOO test, this system automatically decides
whether there are one or two FOOs.
3.19.2 Operations
CAUTION: 00 not forget to load a work disk. If a work disk is
not loaded, an error will be generated during FDD
testing.
1. Remove the diagnostics disk and insert the work disk into
the floppy disk drive.
2. After pressing 6 and Enter to select from the DIAGNOSTIC
MENU, the following message will appear.
Printer wrap around test (YIN) ?
3. Select whether to execute the printer wraparound test (Yes)
or not (No). Type the desired Y or N and press Enter key.
(If Y is selected, a wraparound connector must be connected
to the printer connector on the back of the unit.) The
following message will appear.
Async wrap around test (YIN) ?
4. Select whether to execute the test (Yes) or not (No). Type
the desired Y or N and press Enter Key. (If Y is selected,
an RS232C wraparound connector must be connected to the
COMMS connector on the back of the unit.)
5. This program is repeated continuously. To stop the program,
press Ctrl + Break key.
3-37