Installing the Keyboard
To
install the T1900fr1900C's keyboard, follow the steps below and refer
to
Figures 4-7 and
4-8.
1.
Connect the keyboard cable to pressure-plate connector PJ4 on the upper
system board (Figure 4-7).
2. Seat the keyboard
in
the computer. Note that a fold is built into the keyboard
cable.
Do
not try
to
bend the cable at any other point when you install the key-
board. (Figure 4-8).
Keyboard
cable
I
Figure 4-8 Seating the Keyboard
3. Install the
top
cover, optional PCMCIA card, optional memory card and battery
pack as described in Sections 4.5 through 4.2.
4-13
To Next Page
Loading...
