Toshiba T1900 Series - Hard Disk and Backup Battery Handling

4.7 Hard Disk Drive· Backup Battery
Removing the Hard Disk Drive· Backup Battery
To remove the T1900rr1900C's hard disk drive and backup battery, follow the steps below
and refer
to Figures 4-9 through 4-12.
4-14
I.
Tum off the power to the T 1900rr 1900C, and, if attached, disconnect the AC
adapter, power cord and
all external cables connected to the computer.
2. Remove the battery pack, optional memory card, optional
PCMCIA card, top
cover, and keyboard as described in Sections 4.2 through 4.6.
3. Remove the tape next to the keyboard connector (pJ4).
4. Remove the
rIVe ID.S:!.6 screws securing the keyboard base plate to the bottom
cover and lift
off the plate (Figure 4-9).
Keyboard base plate
Figure 4-9 Removing the Keyboard Base Plate
5. Remove the tape over the backup battery cable and lift out the backup battery
(Figure 4-10).
NOTE: The connector (PJ50J) for the backup battery cable is easily accessible
upon removal of the HDD, therefore remove the HDD before attempting to
disconnect the cable.