9. Remove the
four
flat-head M3x4 screws securing the
bracket
to the IIDD and
slip
off
the bracket (Figure 4-12).
Bracket
---.--1-
M3x4 flat-
head screws
Figure 4-12 Removing the Bracket from the HDD
Installing the Hard Disk Drive and Backup Battery
To
install the T1900tr1900C's hard disk drive and backup battery, follow the steps below and
refer
to
Figures 4-9 through 4-13.
4-16
I. Secure the
bracket
with the
four
Oat-head M3x4 screws (Figure 4-12).
2. Connect the
backup
battery
cable
to
PJS03 (Figure 4-10).
3.
Place the HDD into the HOD slot, and slide the HOD
to
the back. Make sure the
HDD connector connects
to
the lower system board connector (pJ203) correctly
as shown in Figure 4-13.
Figure
4-13
Connecting
the
HDD
to
the
System
Board
To Next Page
Loading...
