4.
Route the backup battery cable
in
the space between the HDD and the battery
cable insulator, then place the
backup battery
in
the backup battery slot (Figure
4-10).
5.
Replace the tape over the backup battery cable.
6.
Secure the
Ml.5s.'
screw at the front
of
the HDD (Figure 4-11).
7.
Set the keyboard base plate
in
place and secure it with the
rIVe
Ml.5s.6
screws
(Figure 4-9).
8.
Replace the tape next
to
the keyboard connector (PI4).
9.
Install
the keyboard, top cover, optional PCMCIA card, optional memory card and
battery pack as described
in
Sections 4.6 through 4.2.
4-17
To Next Page
Loading...
