4.8
Display Mask
Removing the Display Mask
To
remove the
T1900ff1900C's
display
mask,
follow the steps below and refer
to
Figure 4-
14.
4-18
1.
Tum
off
the power
to
the
T1900ff1900C, and, ifattached, disconnect the AC
adapter, power cord and all
external cables connected
to
the computer.
NOTE: It is not necessary
to
remove
the
display assembly from
the
com-
puter
to
remove
its components
2. Remove the
two
screw
coven
from the display hinges
to
expose
two
screws
securing the
display
mask.
3. Remove
the
two
Ml.Sx6
silver screws that were covered by the screw covers.
4. Carefully
insert
your fingers between the mask and
the
LCD panel and pry open
the latches. Start with
the
four
latches across the
top
of
the
display mask.
5.
Continue unlatching the mask along the sides
(four
latches
on
each side), at the
bottom,
two
latches, and display supports. There is also one latch at the small
support and three latches at the larger support not indicated in
the
illustration.
~~_.,
~.,.
Screw
cover
---~
-,
Figure 4-14 Removing
the
Display Mask
To Next Page
Loading...
