4.9 Display Assembly
Removing the Display Assembly
To
remove the
T1900rr1900C's
display assembly, follow
the
steps below and refer
to
Figures
4-15 through 4-17.
4-20
1.
Turn
off
the power
to
the T
1900rr
1900C, and,
if
attached, disconnect the AC
adapter, power cord and
all external cables connected
to
the computer.
2. Remove
the
battery pack, optional memory card, optional PCMCIA card,
top
cover, keyboard, keyboard base plate, and display
mask
as described in Sections
4.2 through 4.S.
3.
Set the display
unit
at a
90
0
angle
to
the base and remove the
two
binge
coven
from
the
left and right hinges (Figure 4-15).
Figure
4-15 Removing
the
Hinge
Covers
4. Remove the four
Ml.Sx8
silver screws and
two
Ml.SxlO screws
on
the system
board
cover
(Figure 4-16).
Note
that the M2.5xS screw
under
the
binge secures
the ground wire.
5.
Peel back
the
clear plastic
insulator
covering the display cable and lift
out
the
system
board
cover. As you lift the cover, place your fingers under the right side
to
keep the
memory
card
bousing
intact.
To Next Page
Loading...
