Toshiba T1900 Series - Page 127

M2.5x8 silver
screws
Plastic insulator
'\ ,.,:- - .. ~
~~;b
_ "~r.... ~
M2.Sx10 screws . ---- ----
Figure 4-16 Removing the System Board Cover
6. Disconnect the two display cables from PJ7 and PJ8 on the system board (Figure
4-17).
7.
8.
9.
I NOTE: The TI900 has only one display CIIble: PI7.
Carefully disconnect the display sensor switch cable from P Jll on the system
board.
Remove the Ml.5x6 sOver screw at the back right comer of the computer.
Lay the display back fully (put a book or small box behind the display to support
it) and remove the two Ml.5x8 sOver screws on the display hinges securing the
display, then lift off the display assembly.
M2.5x6 silver screw
screw
Display sensor switch cable
Figure 4-17 Removing the Display Assembly
4-21