Installing
the
Display Assembly
To install the T1900rr1900C's display assembly, follow the steps below and refer
to
Figures
4-15 through 4-17.
4-22
1.
Place the display assembly on the computer aligning the brackets with the screw
holes on the middle-frame assembly.
Be
sure
to
route the clear plastic insulator
between the display assembly and the bottom chassis (Figure 4-17).
2.
Replace the two
Ml.5x8
snver
screws on the display binges
to
secure the display
assembly.
CAUTION:
If
you
replace a cable with a new one, be sure to
bend
and
route
it
as
indicated in Figures 4-15 through 4-17 so that
it
fits
snugly and
will
not
be pinched
by
the top cover
or
other components.
3.
Connect the display sensor switch cable to P
Jll
on the system board (Figure 4-
17) .
4. Connect the
two display cables
to
PJ7
and
PJ8
on the system board (Figure 4-
17).
5.
Secure the
Ml.5x6
sOver screw on the back
of
the computer (Figure 4-17).
6.
Set the system
board
cover in place and secure the display
ground
wire with an
Ml.5x8
silver screw (Figure 4-16).
7.
Secure the system
board
cover with
three
Ml.5x8
snver
screws and two
Ml.5xlO
screws (Figure 4-16).
8.
Place the clear plastic
insulator
over the display cables and press it so that it
adheres
to
the system
board
cover (Figure 4-16).
9.
Set the display unit at a 90
0
angle
to
the base and insert the two hinge
coven
under the left and right binges (Figure 4-15).
10.
Install the display mask, keyboard base plate, keyboard, top cover, optional
PCMCIA card, optional memory card, and battery pack as described in Sections
4.8 through 4.2.
To Next Page
Loading...
