Installing the Upper System Board
To install the T1900ff1900C's upper system board, follow the steps below and refer
to
Figure 4-18.
4-24
I. Place the
upper
system
board
on the lower system board aligning connectors
PJS
and PJIO. Press the
VGA
port
area
to
seat the upper right comer
of
the system
board, then press the PJ5 and
PJIO connectors
to
connect the upper system board
to
the lower system board.
CAUTION:
When
you
install
the
upper system
board,
be
careful not to cover
the
RTC battery cable and mouselKB
cable.
These
cables must
be
connected
to
the
P J2 and P J3 connectors on
the
upper system board
2.
Secure the Ml.Sx6 screw on the left side
of
the upper system board, and the
Mlx8
screw on the optional memory
card
connector.
3.
Connect the
RTC
battery
cable
to
PJ2,
and mouseIKB cable
to
PJ3.
4. Install the display assembly, display
mask, lIDO, keyboard, top cover, optional
PCMCIA card, optional memory card and battery pack as described in Sections
4.9 through 4.2.
To Next Page
Loading...
