6. Remove the
three
M2I3
black screws securing the FDD
bracket
and remove the
bracket (Figure 4-25).
M2x3black
FDD bracket
~
..
-.-
- M2x3 black screw
Figure 4-25 Removing
the
FDD
Bracket
Installing the Floppy Disk Drive and Mouse/KB Board
To
install the T1900rr1900C's floppy disk drive and mouseIKB board, follow the steps below
and refer
to
Figures 4-23 through 4-25.
4-30
I. Place the FDD
bracket
on
the FDD and secure it with the
three
MlI3
black
screws (Figure 4-25).
2. Secure the mouseIKB
board
with two
Ml.5x4
screws
to
the FDD bracket
(Figure 4-24).
3. Place the
FDD
Dsembly
in the computer, right side first, and secure the mousel
KB
board
with two
Ml.5x6
screws (Figure 4-23).
4.
Install the lower system board, upper system board, display assembly, display
mask,
lIDO, status indicator
pane~
keyboard, top cover, optional PCMCIA card,
optional memory card and battery pack as described in Sections 4.11 through 4.2.
To Next Page
Loading...
