~rEi:::ll~+-CN3
Figure 4-27 Removing the FL Inverter
Board
Installing
the
T1900C FL Inverter Board
To install the T1900C's FL inverter board, follow the steps below and refer to Figures 4-26
and 4-27.
4-32
1.
Connect the
FL
inverter cable
to
CNl
on the inverter
board
and
the two
FL
cables
to
CNl
and CN3 (Figure 4-27).
2.
Route the cables so they are not pinched by the
FL
inverter board, display
hinge
or
other component.
3. Replace the
FL
inverter
board
and secure it with the two
Ml.5x6
screws (Figure
4-27).
4.
Set the display
support
plate in place and secure it with
four
Ml.5x6
screws.
One screw also secures the display ground cable (Figure
4-26).
5.
Install the display
mask,
top cover, optional PCMCIA card, optional memory card
and battery pack as described in Sections
4.8, 4.5, 4.4, 4.3 and 4.2.
To Next Page
Loading...
