4.15 T1900C Fluorescent Lamp (FL)
Removing the T1900C FL
To remove the T1900C's FL, follow the steps below and refer
to
Figures 4-29 through 4-31.
1.
Tum
off
the power
to
the T1900ff1900C, and, ifattached, disconnect the
AC
adapter, power cord and
all
external cables connected
to
the computer.
2.
Remove the battery pack, optional memory card, optional PCMCIA card, top
cover, display mask, display assembly, FL inverter board, and LCD module as
described in Sections
4.2,4.3,4.4,4.5,4.8,4.9,4.13
and 4.14.
3.
Lay the color LCD module
face
down and use needle-nose pliers
to
unbend the
16 latches holding the front and back frames together. Then
lift
the unit out
of
the
front frame (Figure 4-29).
Figure 4-29 Unbending
the
Color LCD Module Latches
4-35
To Next Page
Loading...
