Installing the FL Inverter Board
To install the T1900's FL inverter board, follow the steps below and refer
to
Figures 4-32 and
4-33.
I. Connect the
FL
inverter
cable and
FL
cables
to
eNl
and
CNl
on the FL in-
verter board (Figure
4-33).
2.
Seat the
FL
inverter
board
and route the cables so they will not be pinched by
the display cover
or
other component.
3. Secure the
FL
inverter
board
with one
Ml.5x6
screw (Figure 4-33).
4.
Set the display
support
plate
in place and secure it with
rIVe
Ml.5x6
screws.
One screw also secures the display
ground
cable (Figure 4-32).
5.
Install the display assembly, display
mask,
top cover, optional PCMCIA card,
optional memory card and battery pack as described in Sections
4.9,4.8,4.5,4.4,
4.3 and 4.2.
4-39
To Next Page
Loading...
