Installing the Liquid Crystal Display Module
To
install the T1900's liquid crystal display module, follow the steps below and refer
to
Figure
4-34.
I. Connect the
two
display cables
to
CNt
and
CNl
on
the LCD module.
2. Place the
module
in the cover and route the cables so they will not be pinched by
the display panel
or
other components.
3. Secure the panel with
two
Ml.Sx6
screws.
4. Install the
FL
inverter board, display assembly, display mask, top cover, optional
PCMCIA card, optional memory card and battery pack as described in Sections
4.16,4.9,4.8,4.5,4,4,4.3
and 4.2.
4-41
To Next Page
Loading...
