6.
Select the desired subtest from the subtest menu and press
Enter.
The
follOwing
messages appear:
TEST
LOOP
:
YES
ERROR
STOP
:
YES
Use the arrow keys
to
move the cursor
to
the desired option and press
Enter.
Selecting
YES
for
lEST
LOOP sets the test
to
run continuously until it is halted
by the user. Selecting
NO
returns the screen
to
the
main
menu after the test is
complete.
Selecting
YES
for ERROR STOP stops the test program when an error is found
and displays the operation guide
on
the right side
of
the display screen as shown
below:
ERROR
STATUS
NAME
[[
HALT
OPERATION
]]
1:
Test
end
2:
Continue
3:
Retry
These three selections have the following functions:
1:
Terminates the test program and exits
to
the subtest menu.
2: Continues the test.
3: Restarts the test from the error.
Use the arrow keys
to
move the cursor
to
the desired option and press
Enter.
Selecting
NO
for ERROR STOP keeps the test running even
if
an error is found.
Table 3-1 in
Section 3.3 describes the function
of
each test
on
the subtest menu. Table 3-3 in
Section 3.14' describes the error codes and error status for each error.
3-5
To Next Page
Loading...
