1.
All track FORMAT
Pressing
1 selects "All track FORMAT," which formats the entire disk.
[All
track
FORMAT]
Drive
Cylinder
Head
Sector
#1
=
HDD
XXXX
xx
XX
«<
Model
name
»>
#2
Non
The following questions also appear at the bottom
of
the
screen in succession:
Drive
number
select
(1:#1,2:#2)
?
(1) Select a drive number and press
Enter.
The following message appears:
Interleave
number
(1/1
-
8)
?
(2) Select an interleave number
(1
- 8) and press
Enter.
Pressing only
Enter selects
1.
Unlock
format
select
(1:no/2:yes)
(3) Select whether the disk has an unlock format.
NOTE: This option appears only when an HDD manufactured
by
JVe
is
installed. For
JVe
HDDs, which are the only disks with unlock formats, you
must select 2 (yes).
If
1 is selected with a
JVe
disk, an error will be gener-
ated. The
system defaults to 1
and
this message does
not
appear when other
disks are installed.
(4)
Bad
track register
Next, the
Bad
Track register prompt will appear as shown below. Enter
the cylinder and head numbers
of
bad tracks and press
Enter.
Note
that
if
there are
no
bad tracks, pressing Enter alone is
the
same as executing
All Track Format described
in
Item (5) below.
[ WARNING:
Current
DISK
data
will
be
completely
destroyed
]
Press
Bad
cylinder
number
(dddd)]
key?
Press
Bad
head
number
(dd)]
key?
Enter the cylinder and head number in
the
format above in decimal
notation. Repeat for each bad track you want
to
format.
After entering the bad tracks, press
Enter
to
execute the format.
3-39
To Next Page
Loading...
