Installing the Fluorescent Lamp
To install the T1900’s fluorescent lamp, follow the steps below and refer to Figure 4-35.
1. Place the fluorescent lamp in position in the LCD module.
2. Slip the edge of the plastic cover under the metal frame and align the holes in the
cover with the corresponding holes in the display assembly cover.
3. Secure the plastic cover with the three flat-head M1.5x3 brass screws.
4. Secure the FL cable to the LCD panel with tape as indicated in Figure 4-35.
5. Install the LCD panel, FL inverter, display assembly, display mask, top cover,
optional PCMCIA card, optional memory card and battery pack as described in
Sections 4.17, 4.16, 4.9, 4.8, 4.5, 4.4, 4.3 and 4.2.
To Next Page
Loading...
