Toshiba T2150 series - Installing the CD-ROM Drive

T2150 Series
4-25
4. Remove four M2x3 black screws securing the bracket to the CD-ROM drive and
slip off the bracket (figure 4-20).
Figure 4-20 Removing the HDD
Installing the CD-ROM Drive
To install the T2150 series CD-ROM drive, follow the steps below and refer to figures 4-19
and figures 4-20.
1. Secure the bracket to the HDD with four M2x3 black screws (figure 4-20).
2. Place the CD ROM drive in the computer, and connect the CD-ROM cable to
PJ8, then secure to the system board and the CD-ROM front cover with three
M2.5x6 screws (figure 4-19).
3. Install the AC PS unit, display assembly, top cover, hard disk drive, keyboard,
optional memory module, optional PCMCIA card, and battery pack as described in
sections 4.8 back through 4.2.