Toshiba T2150 series - Page 150

T2150 Series
4-35
5. Lift the LCD module out of the frame.
6. Gently grip the FL cable’s connector with a pair of needle nose pliers and discon-
nect the FL cable. Be very careful not to damage the connector and cable (figure
4-26).
7. Remove four M2x4 screws securing the SEG board and rotate the board out so
that it lies flat. Be sure no dust or debris contaminates the unit (figure 4-26).
Figure 4-26 Removing screws
8. Remove the two ground plates at each end of the SEG board (figure 4-26).
9. Slip your finger under the P chassis and release the latch securing it to the B/L
holder. Gently hold down the LCD module and lift one side of the B/L holder as
shown in figure 4-27. As you lift the B/L holder the P chassis securing the holder
will rotate out.