Toshiba T2150 series - 4.15 T2150 CDT FL Inverter Board; Removing the T2150 CDT FL Inverter Board

4-38
T2150 Series
4.15 T2150CDT FL Inverter Board
Removing the T2150CDT FL Inverter Board
To remove the T2150CDT’s FL inverter board, follow the steps below and refer to figure
4-29.
1. Turn off the computer's power. Disconnect the AC power cable and all external
cables connected to the T2150CDT.
2. Remove the battery pack, optional memory module, optional PCMCIA card, and
display mask as described in sections 4.2 through 4.4, and 4.11.
3. Remove the microphone and two M2.5x6 screws securing the FL inverter
board.
4. Rotate the FL inverter board out of its seating and disconnect the FL inverter
cable from CN1 and the FL cable from CN2 on the FL inverter board (figure
4-29).
Figure 4-29 Disconnecting the FL inverter board