T2150 Series
Installing the T2150CDT Color LCD Module
To install the T2150CDT’s color LCD module, follow the steps below and refer to figure
4-30.
1. Connect the display cable to the LCD module, and carefully rotate the LCD
module into place in the display cover (figure 4-30).
2. Secure four M2.5x6 screws with the ground cable on the LCD module (figure
4-30).
3. Install the FL inverter board, display mask, optional memory module, optional
PCMCIA card, and battery pack as described in sections 4.15, 4.11, 4.4 back
through 4.2.
To Next Page
Loading...
