T2150 Series
3.2 Executing the Diagnostic Test
Toshiba MS-DOS is required to run the T2150 series DIAGNOSTICS PROGRAM. To start
the DIAGNOSTIC PROGRAM follow these steps:
1. Turn on the computer, and allow the computer to boot. Insert the T2150 series
Diagnostics disk in the computer’s external floppy disk drive.
2. At the system prompt, change to drive A and type TEST2150 or CDROMDRV
(CD-ROM test only), and press Enter.
The following menu will appear:
TOSHIBA personal computer T2150CDx DIAGNOSTICS
version X.XX (c) copyright TOSHIBA Corp. 19XX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 - HARD DISK FORMAT
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
↑↓→← : Select items
Enter : Specify
Esc : Exit
NOTE: To exit the T2150 series DIAGNOSTIC TEST MENU, press the Esc key. If a
test program is in progress, press Ctrl + Break to exit the test program or press Ctrl +
C to stop the test program.
To Next Page
Loading...
