T3400, T3400CT
5. Remove the FL from the display module (Figure 4-28).
Figure 4-28 Removing the FL
Installation
To install the monochrome fluorescent lamp, follow the steps below and refer to Figures 4-27
and 4-28.
1. Seat the FL (Figure 4-28).
2. Seat the FL cover and secure it with three brass M2x2 flat-head screws (Figure
4-27).
3. Replace the display module, FL inverter board, display mask, and battery pack as
described in sections 4.15, 4.14, 4.13, and 4.2.
To Next Page
Loading...
