T3400, T3400CT
5. Disconnect the display cable and lift out the display module (Figure 4-30).
Figure 4-30 Removing the Display Module
Installation
To install the color display module, follow the steps below and refer to Figures 4-29 and 4-30.
1. Connect the display cable to the display module, routing the cable back under
the clear plastic insulator. (Figure 4-30).
2. Seat the display module in the display cover and secure four brass M2x6 screws,
one at each corner of the module (Figure 4-29).
NOTE: Secure the ground cable at the bottom right corner with one of the screws.
3. Replace the FL inverter board, display mask, and battery pack as described in
sections 4.14, 4.13, and 4.2.
To Next Page
Loading...
