T3400, T3400CT
5. Select a subtest from the menu and press Enter. The following messages appear:
TEST LOOP : YES
ERROR STOP : YES
Use arrow keys to move the cursor to an option and press Enter.
Selecting YES for TEST LOOP sets the test to run until halted by the user. Select-
ing NO exits to the main menu after the test is complete.
Selecting YES for ERROR STOP stops the test when an error is found and dis-
plays the operation guide on the right side of the display screen as shown below:
ERROR STATUS NAME [[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
These three selections have the following functions:
1: Terminates test and exits to subtest menu.
2: Continues test.
3: Restarts test from the beginning.
Use arrow keys to move the cursor to an option and press Enter.
Selecting NO for ERROR STOP keeps a test running even if an error is found.
Table 3-1 in section 3.3 describes each subtest menu test function; Table 3-3 in section 3.14
lists codes and status for each error.
To Next Page
Loading...
