T3400, T3400CT
Installation
To install an optional memory card, follow the steps below and refer to Figures 4-3 through
4-5.
1. Insert the memory module, connector edge first, into the computer connectors.
The notch at the corner of the module should be on the right as the module is
inserted (Figure 4-5).
Figure 4-5 Inserting the Memory Module
2. The module is supported by springs in the memory module socket. Gently push
the module into place until two latches close over each side (Figure 4-4).
3. Fit the socket cover latches into place and seat the cover (Figure 4-3).
4. Secure the two M2.5x4 screws (Figure 4-3).
5. Install the battery pack as described in section 4.2.
To Next Page
Loading...
