Toshiba T3400CT - Top Cover Installation Steps

T3400, T3400CT
4-13
Installation
To install the top cover, follow the steps below and refer to Figures 4-8 through 4-10.
1. Set the back edge of the top cover in place and connect the display cable to PJ10,
LED cable to PJ16, keyboard cable to PJ8, and AccuPoint cable to PJ503
(Figure 4-10).
2. Turn the computer upside down and press firmly at the display latch until the
bottom and top covers snap into place (Figure 4-9).
3. Close the computer, and secure the top cover with seven M2.5x8 silver screws
and two M2.5x4 screws (Figure 4-8).
4. Replace the optional PCMCIA card, optional memory card, and battery pack as
described in sections 4.4 through 4.2.