T3400, T3400CT
Installation
To install the system board, follow the steps below and refer to Figure 4-16.
1. Connect the system board to the power supply/system joint board (Figure 4-
16).
2. Seat the system board into the bottom cover (Figure 4-16).
NOTE: Be careful with the PCMCIA card eject button, it may be necessary to open the
PCMCIA slot cover for the button to clear the bottom cover. Be sure to match the
guide pins with the corresponding holes in the board.
3. Secure the system board to the bottom cover with one M2x6 screw.
4. Replace the RTC and backup batteries, hard disk drive, top cover, optional
PCMCIA card, optional memory card, and battery pack as described in sections
4.7 through 4.2.
To Next Page
Loading...
