T3400, T3400CT
Installation
To install the display mask, follow the steps below and refer to Figure 4-22.
1. Set the display mask in place and press firmly to secure the latches. Start at the
bottom five latches and work your way around the sides (four latches at each
side) to the three latches at the top (Figure 4-22).
2. Secure two brass M2x6 screws at the top of the display cover and two brass
M2.5x6 screws at the bottom (Figure 4-22).
3. Replace the two rubber pads and two screw covers (Figure 4-22).
4. Replace the battery pack as described in section 4.2.
To Next Page
Loading...
