Toshiba T3400CT - Monochrome Display Module Procedures; Monochrome Display Module Removal Steps

T3400, T3400CT
4-33
4.15 Monochrome Display Module
Removal
To remove the monochrome display module, follow the steps below and refer to Figures 4-24
through 4-26.
1. Turn off the power to the computer and disconnect the AC adapter, power cord,
and all external cables.
2. Remove the battery pack, display mask, and FL inverter board as described in
sections 4.2, 4.13 and 4.14.
3. Remove four brass M2x6 screws at each corner of the display module. The screw
at the bottom right corner also secures the ground cable (Figure 4-24).
4. Rotate the display panel out so that it lies flat on an ESD-protected surface
(Figure 4-24).
Figure 4-24 Removing the Display Module Screws