T4900CT
4.4 Optional PCMCIA Card
Removing an Optional PCMCIA Card
The T4900CT has two PCMCIA slots: one for a card up to 5.0 mm (slot 2) and one for a card
up to 16 mm (slot 1). To remove optional PCMCIA cards, follow the steps below and refer
to figures 4-4 through 4-6:
1. Turn off the power to the T4900CT. Disconnect the AC adapter, power cord, and
all external cables connected to the T4900CT.
2. Remove the battery pack as described in section 4.2.
3. To remove a card from the PCMCIA card slot 2 (center), pull up the slot cover to
expose the card.
4. Push the eject button to pop the card slightly out, then grasp the card and pull it
completely out (figure 4-4).
Figure 4-4 Removing the card from the PCMCIA card slot 2
5. To remove a card from the PCMCIA card slot 1, slip your fingernail or a thin
object under the notch at the top of the cover and snap off the cover (figure 4-5).
Figure 4-5 Removing the PCMCIA card slot 1 cover
To Next Page
Loading...
