Central Remote Controller Installation Manual
14
-EN
3-2. How to Install
■ When installing to control board (control panel) or to a wall
The thickness of the board or wall must be 1.6 mm to 10 mm.
• Prepare the holes for installation beforehand, following the the diagram below (Panel cut dimensions diagram).
• Remove 1 panel fixing screw and open the panel.
• Attach the lower case with the four included fixing screws.
• Close the panel and attach it with 1 panel fixing screw.
CAUTION
• Do not wire communication lines (control wiring between indoor and outdoor units, central control wiring) or input/output
wiring next to power supply wiring, etc., or house them in the same metal pipe. Doing so may result in failure.
• Install the central remote controller away from noise sources.
50 50
42 42
Panel
Control board or a wall
Panel fixing screw
Lower case
Fixing screws
< Panel cut dimensions diagram >
W:95 × H:84
Square hole
Screw holes (4 places)
47.5 47.5
To Next Page
Loading...
